Home > Networking > Switches > IBM Switches > IBM BNT RackSwitch G8000R

IBM BNT RackSwitch G8000R

Mfg Part #: 0446013


IBM BNT RackSwitch G8000R

Ordering Information
MSRP$6,999.00
Our Price$4,681.33
FREE SHIPPING
ConditionNew and Factory Sealed
Out of Stock as of 2:47am 3/29/2014
Qty

IBM BNT RackSwitch G8000 is a Top of the Rack (TOR) switch that delivers unmatched line-rate Layer 2/3 performance at a very attractive price. It has 44x 1 GbE RJ45 ports, four 1 G SFP ports, and standard redundant power supplies. Unlike most rack equipment that cools from side to side, the RackSwitch G8000 has rear-to-front airflow that matches server airflow.

High performance
The G8000 provides up to 176 Gbps throughput and supports up to four 10 G uplink ports for a very low oversubscription ratio.

Lower power and better cooling
The G8000 uses less power than two 60 W light bulbs - a fraction of the power consumption of most competitive offerings. Unlike side-cooled switches, which can cause heat recirculation and reliability concerns, the G8000 rear-to-front cooling design reduces data center air conditioning costs by matching airflow to the server's configuration in the rack. Variable speed fans assist in automatically reducing power consumption.

Layer 3 functionality
The switch includes Layer 3 functionality, which provides security and performance benefits, as inter-VLAN traffic stays within the chassis. This switch also provides the full range of Layer 3 static and dynamic routing protocols including Open Shortest Path First (OSPF) and Border Gateway Protocol (BGP) for enterprise customers.

Active MultiPath (AMP)
This effectively doubles bandwidth by allowing all uplink ports to be active/active, eliminating cross-stack traffic and providing up to 900 Gbps aggregate bandwidth between servers. Built-in fault tolerance constant health checking ensures maximum availability.

Fault tolerance
These switches learn alternate routes automatically and perform faster convergence in the unlikely case of a link, switch, or power failure. The switch uses proven technologies such as L2 trunk failover, advanced VLAN-based failover, VRRP, HotLink, Uplink Failure Detection (UFD), IGMP V3 snooping, and OSPF.

Seamless interoperability
Switches interoperate seamlessly with other vendors' upstream switches.

Stacking
Cluster virtualization, single IP, and stacking of up to six virtual switches allow configuration of multiple switches as one, saving valuable time, IP addresses, and resources.


Product Highlights
  • The G8000 comes standard with redundant power supplies and rail kits
  • The G8000 is designed specifically for the data center environment: airflow, high-availability hardware and software features, rich Layer 2/3 functionality, and ease of management
  • The G8000 supports stacking for up to six switches using a single switch image and configuration file that shares one IP address and one management interface

In The Box
  • BNT RackSwitch G8000R
  • 3 m
  • Rack mounting kit

Our company is a IBM authorized sales and service center.

General Specifications

ManufacturerIBM
Manufacturer Part #0446013
Manufacturer UPC #0883436025867
Cost Central Item #11200507
Product DescriptionBNT RackSwitch G8000R - Switch - L3 - managed - 44 x 10/100/1000 + 4 x SFP - rack-mountable
Device TypeSwitch - 44 ports - L3 - managed
Enclosure TypeRack-mountable 1U
InterfacesGigabit Ethernet
Ports44 x 10/100/1000 + 4 x SFP
PerformancePort-to-port latency : 4 ms
Throughput : 176 Gbps
CapacityStatic routes : 128
MAC Address Table Size16K entries
Routing ProtocolOSPF, RIP-1, RIP-2, BGP, IGMPv2, IGMP, VRRP, IGMPv3
Remote Management ProtocolSNMP 1, RMON, SNMP 3, SNMP 2c, HTTPS, TFTP, SSH, SSH-2
FeaturesFlow control, fault tolerance, layer 3 switching, layer 2 switching, DHCP support, trunking, VLAN support, IGMP snooping, port mirroring, IPv6 support, firmware upgradable, SNTP support, sFlow, Rapid Spanning Tree Protocol (RSTP) support, Virtual Route Redundancy Protocol (VRRP) support, Multiple Spanning Tree Protocol (MSTP) support, Quality of Service (QoS), RADIUS support, SSH support, Jumbo Frames support, back to front airflow, Rapid Per-VLAN Spanning Tree Plus (PVRST+), LACP support, LLDP support
Compliant StandardsIEEE 802.1Q, IEEE 802.1p, IEEE 802.3x, IEEE 802.3ad (LACP), IEEE 802.1w, IEEE 802.1x, IEEE 802.1s, IEEE 802.1ab (LLDP)
PowerAC 120/230 V ( 50/60 Hz )
Power RedundancyYes
Approximate Dimensions (WxDxH)17.3 in x 15 in
Approximate Weight12.1 lbs
Manufacturer Warranty3 years warranty

Extended Specifications

General
Device TypeSwitch - 44 ports - L3 - managed
Enclosure TypeRack-mountable - 1U
InterfacesGigabit Ethernet
Ports44 x 10/100/1000 + 4 x SFP
PerformancePort-to-port latency : 4 ms
Throughput : 176 Gbps
CapacityStatic routes : 128
MAC Address Table Size16K entries
Routing ProtocolOSPF, RIP-1, RIP-2, BGP, IGMPv2, IGMP, VRRP, IGMPv3
Remote Management ProtocolSNMP 1, RMON, SNMP 3, SNMP 2c, HTTPS, TFTP, SSH, SSH-2
Authentication MethodSecure Shell (SSH), RADIUS, TACACS+, Secure Shell v.2 (SSH2)
FeaturesFlow control, fault tolerance, layer 3 switching, layer 2 switching, DHCP support, trunking, VLAN support, IGMP snooping, port mirroring, IPv6 support, firmware upgradable, SNTP support, sFlow, Rapid Spanning Tree Protocol (RSTP) support, Virtual Route Redundancy Protocol (VRRP) support, Multiple Spanning Tree Protocol (MSTP) support, Quality of Service (QoS), RADIUS support, SSH support, Jumbo Frames support, back to front airflow, Rapid Per-VLAN Spanning Tree Plus (PVRST+), LACP support, LLDP support
Compliant StandardsIEEE 802.1Q, IEEE 802.1p, IEEE 802.3x, IEEE 802.3ad (LACP), IEEE 802.1w, IEEE 802.1x, IEEE 802.1s, IEEE 802.1ab (LLDP)
Status IndicatorsStatus
Expansion / Connectivity
Interfaces44 x 1000Base-T - RJ-45
1 x console - management
4 x SFP (mini-GBIC)
Power
Power DeviceInternal power supply - hot-plug
Installed Qty2 (installed) / 2 (max)
Power RedundancyYes
Power Redundancy Scheme1+1
Voltage RequiredAC 120/230 V ( 50/60 Hz )
Miscellaneous
Cables Included1 - 10 ft
Rack Mounting KitIncluded
MTBF195,000 hours
Dimensions & Weight
Approximate Width17.3 in
Approximate Depth15 in
Approximate Weight12.1 lbs
Manufacturer Warranty
Service & Support3 years warranty
Service & Support DetailsLimited warranty - 3 years
New releases update - 3 years
Environmental Parameters
Min Operating Temperature32 °F
Max Operating Temperature104 °F
Humidity Range Operating10 - 90% (non-condensing)

Available Accessories & Related Products

Networking - Network Adapters
DescriptionMfg Part #StockPrice 
IBM RackSwitch 10Gb Dual-Port SFP+ Uplink ModuleIBM RackSwitch 10Gb Dual-Port SFP+ Uplink Module
Expansion module - 10 Gigabit LAN - 2 ports - for BNT RackSwitch G8000DC, RackSwitch G8000F, RackSwitch G8000R
46C3417 No $562.03

Service and Support - Networking
DescriptionMfg Part #StockPrice 
IBM ServicePac Remote Technical SupportIBM ServicePac Remote Technical Support
Technical support - emergency phone consulting - 1 year - 24x7 - 2 h - for BNT RackSwitch G8000, RackSwitch G8124; Ethernet Switch B24, B48; System Storage SAN48
91Y8857 No $272.90
IBM ServicePac Remote Technical SupportIBM ServicePac Remote Technical Support
Technical support - emergency phone consulting - 3 years - 24x7 - for BNT RackSwitch G8000, RackSwitch G8124; Ethernet Switch B24, B48; System Storage SAN48
91Y8858 No $696.58

Customer Care
Help Desk
Web Site Features
Company Information

Total time: 0.0852 seconds