Perle eXP-S110-XT PoE Fast Ethernet extenders transparently extend Ethernet beyond the general IEEE 802.3af limits of 328 ft/100 m while providing Power over Ethernet (PoE) to standards-based compliant devices such as IP cameras and wireless access points located in extreme temperature environments.
This technology enables users to transparently extend up to four 10/100 Power over Ethernet connections across copper wiring. At the central site, the 10/100 Ethernet extender has full PoE support and operates as a Powered Device (PD) under IEEE 802.3af supporting end-span and mid-span power sources (PSE). Alternatively, the unit can be powered by the included 48 V adapter. The PoE Ethernet extender at the central site then transmits power over the copper wire to power the remote PoE Ethernet extender and attached PD.
On-board PoE power controller
As a fully compliant IEEE 802.3af PSE end-span device, this Ethernet extender's PoE power controller provides compliant power provisioning and monitoring, properly sensing through signature detection whether or not the attach Ethernet devices are PoE capable or not. This provides a safe connection for both PoE and Non-PoE capable devices.
PSE status indicator
A multi-color LED provided presents the status of the PSE function for easy troubleshooting of power over Ethernet connections.
Power multiplier selection
When used with 4-pair cable such as CAT5 on the VDSL Interlink port, an optional internal strap selection on the Ethernet extender will provide VDSL transmission data on 1 pair and power across the 3 other pairs enabling even greater distances for power transmission to be achieved.
It utilizes second generation VDSL2 technology. When operating under "Profile 30a", Perle Ethernet extenders can provide an aggregate VDSL line rate capability of up to 200 Mbps.
Plug and Play operation
Perle Ethernet extenders will automatically configure your VDSL interlink connection. The CO/CPE peer association will be determined automatically by the Ethernet extender. No need to set CO/CPE VDSL pairing.
With link pass-through the state of the 10/100Base-TX Ethernet connection is "passed through" the VDSL link to the 10/100Base-TX Ethernet connection on its remote peer. A managed switch on the remote end can then report the state to its network management system so that any errors can be detected and recovered early.
Auto-MDIX (Automatic Medium-Dependent Interface crossover) detects the signaling on the 10/100 Ethernet RJ45 interface and determines the type of cable connected (straight-through or crossover) and automatically adopts a compatible pinout.
Fixed speed and duplex
Some Ethernet equipment require a fixed speed and duplex be used or cannot auto-negotiate. By disabling auto-negotiation on the Ethernet extender, a fixed speed of 10 or 100 mbps as well as full or half duplex can be configured through DIP switches.
Power strain relief strapProduct Highlights
A strain relief strap is provided to ensure a solid and secure power connection to the Ethernet extender. It is ideal for areas that may be exposed to vibration.
- Transparent to IP video compression protocols